Renault Megane, Scenic

Since 1996 of release

Repair and car operation



Reno Megan, Stsenik
+ Cars of mark Renault Megane
+ Maintenance service
+ Engine repair
- System of cooling, heating
   Separation and replacement of hoses of system of cooling
   Removal, survey and radiator installation
   Removal, check of serviceability and thermostat installation
   Serviceability check, removal and electrofan installation
   Serviceability check, removal and installation of gauges of system of cooling
   Removal and installation of the water pump
   The general description of a heater
   Removal and installation of components of a heater (all models except Scenic)
   Removal and installation of components of a heater (model Scenic)
   The general description and precautions - air central air
   Removal and installation of components of a central air of air
+ Power supply systems, release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes



Separation and replacement of hoses of system of cooling

Hoses should be separated only after the engine has cooled down to avoid a burn hot steam and splashes.

 REPLACEMENT

1. Examine, described in the Head Maintenance service, and reveal the damaged hose.
2. Merge a liquid from cooling system. If the cooling liquid is not subject to replacement, collect it in the pure container.

3. Loosen the collars of fastening of a hose. On described models three types of collars are used: worm, spring and coupling. Disposable, and after their removal it is necessary to replace collars of coupling type with standard collars of worm type. Displace collars on a hose from junctions.

4. Accurately remove a hose. New hoses act in film rather easily, on the old car they, probably, have become attached to branch pipes.
5. If to remove a hose it is not possible, try to release it, having turned the end on a branch pipe. Softly wring out the end of a hose a blunt tool (for example, a flat screw-driver), watching to damaging branch pipes or hoses. Remember that the inlet branch pipe of a radiator is fragile; do not make excessive effort at attempt to remove a hose. As a last resort, cut a hose, then cut the become attached end lengthways on two parts. Though hoses expensive enough, all of them are cheaper, than a new radiator.
6. At hose installation at first spread on it collars, then place a hose into position.
7. Be convinced that the hose is laid correctly, then displace collars on its ends tighten them.
8. Fill cooling system.
9. Carefully check up system on presence of leaks.