Renault Megane, Scenic

Since 1996 of release

Repair and car operation



Reno Megan, Stsenik
+ Cars of mark Renault Megane
+ Maintenance service
+ Engine repair
+ System of cooling, heating
+ Power supply systems, release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
- Suspension bracket and steering
   Removal and installation of assemblage of a forward rotary fist
   Check and replacement of bearings of a nave of a forward wheel
   Removal and installation of a forward rack
   Partition of a forward rack
   Removal and installation of the forward stabilizer of cross-section stability
   Removal, partition and installation of the bottom lever of a forward suspension bracket
   Removal and installation of the spherical hinge of the bottom lever of a forward suspension bracket
   Check and replacement of bearings of a nave of a back wheel
   Removal, check and installation of the back shock-absorber
   Removal and installation of the back stabilizer of cross-section stability (back axis of the closed type)
   Removal and installation of a back axis
   The general description of a partition of a back axis
   Check and adjustment of a road gleam of the car
   Removal and steering wheel installation
   Removal, survey and installation of a steering column
   Removal, survey and installation of the steering mechanism
   Removal and installation of the pump of the steering hydraulic booster
   Prorolling of hydrosystem of the steering hydraulic booster
   Replacement of a protective cover of the steering mechanism
   Removal and installation of a tip of steering draught
   Removal and installation of cross-section steering draught
   Corners of installation of wheels
+ Body
+ Onboard electric equipment
+ Electric equipment schemes



Removal and installation of a tip of steering draught

 REMOVAL

1. Cock a manual brake, then поддомкратьте a forward part of the car and establish it on axial props. Remove a forward wheel.
2. If шаровый the hinge is not subject to replacement, by means of a ruler and разметочного the tool mark its position concerning steering draught.
3. Loosen the a coupling bolt of the spherical hinge.
4. Remove a nut, крепящую шаровый the hinge to a rotary fist. Take a core of the hinge by means of a special stripper. If the hinge is not subject to replacement, protect the cut end of its core, again having screwed on it a nut before to use a stripper.
5. Counting up number of turns, turn on шаровый the hinge from steering draught.
6. Accurately clear шаровый the hinge and its carving. Replace a tip of steering draught if the hinge moves in it too freely or hardly if it is worn excessively out or damaged. Attentively examine a cone and a core carving. If the protective cover is damaged, replace a tip of steering draught since to replace a protective cover it is separately impossible.


 INSTALLATION

1. Screw a tip in steering draught on the counted number of turns. The labels made before removal thus should be combined.
2. Establish a core of the spherical hinge and a rotary fist and tighten a fixing nut the effort resulted in Specifications. If to make it it is not possible because of core rotation, block it, having propped up the hinge a jack.
3. Establish a wheel, lower the car on the earth and tighten wheel bolts the effort resulted in Specifications.
4. Check up a convergence of forward wheels as it is described in Section Corners of installation of wheels, then tighten a coupling bolt of the spherical hinge the effort resulted in Specifications.