Renault Megane, Scenic

Since 1996 of release

Repair and car operation



Reno Megan, Stsenik
+ Cars of mark Renault Megane
+ Maintenance service
+ Engine repair
+ System of cooling, heating
+ Power supply systems, release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
- Suspension bracket and steering
   Removal and installation of assemblage of a forward rotary fist
   Check and replacement of bearings of a nave of a forward wheel
   Removal and installation of a forward rack
   Partition of a forward rack
   Removal and installation of the forward stabilizer of cross-section stability
   Removal, partition and installation of the bottom lever of a forward suspension bracket
   Removal and installation of the spherical hinge of the bottom lever of a forward suspension bracket
   Check and replacement of bearings of a nave of a back wheel
   Removal, check and installation of the back shock-absorber
   Removal and installation of the back stabilizer of cross-section stability (back axis of the closed type)
   Removal and installation of a back axis
   The general description of a partition of a back axis
   Check and adjustment of a road gleam of the car
   Removal and steering wheel installation
   Removal, survey and installation of a steering column
   Removal, survey and installation of the steering mechanism
   Removal and installation of the pump of the steering hydraulic booster
   Prorolling of hydrosystem of the steering hydraulic booster
   Replacement of a protective cover of the steering mechanism
   Removal and installation of a tip of steering draught
   Removal and installation of cross-section steering draught
   Corners of installation of wheels
+ Body
+ Onboard electric equipment
+ Electric equipment schemes



Prorolling of hydrosystem of the steering hydraulic booster

This procedure is required only if hydrosystem components have been separated or if air has got to system as a result of leak.

 PROROLLING

1. Uncover the tank and finish level of a liquid to the maximum label. The liquid type is specified in Section the routine maintenance Schedule in the beginning of the given Management.
2. Some times slowly move the steering mechanism from one extreme position to another (the engine is muffled) to remove from it air, then add a liquid in the tank. Repeat this procedure while liquid level in the tank does not cease to go down.
3. Start the engine. Again slowly move the steering mechanism from one extreme position to another to remove remained air. Repeat this procedure while in the tank vials will not cease to appear.
4. If at steering wheel rotation in hydrowire tubes uncharacteristic noise is audible, in system still there was air. Check up it, having turned wheels in position "directly" and having switched off the engine. If liquid level in the tank raises, the further prorolling is necessary.
5. Upon termination of prorolling muffle the engine, allow to system to cool down and be convinced that liquid level is on the maximum label of the tank. If it is necessary, add a liquid in the tank.