Renault Megane, Scenic

Since 1996 of release

Repair and car operation



Reno Megan, Stsenik
+ Cars of mark Renault Megane
+ Maintenance service
+ Engine repair
+ System of cooling, heating
+ Power supply systems, release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
- Brake system
   Prorolling of hydrosystem of brakes
   Replacement of brake tubes and hoses
   Replacement колодок forward brake mechanisms
   Replacement колодок back brake mechanisms
   Survey, removal and installation of a disk of the forward brake mechanism
   Removal, survey and installation of drums of back brake mechanisms
   Removal, partition and installation of supports of forward brake mechanisms
   Removal and installation of the cylinder of the back brake mechanism
   Removal, partition and installation of the main cylinder
   Removal and installation of a pedal of a brake
   Check, removal and installation of the block of the vacuum amplifier
   Removal, check and installation of the unilateral valve of the block of the vacuum amplifier
   Adjustment of a manual brake
   Removal and installation of the lever of a manual brake
   Removal and installation of ropes of a manual brake
   Check, removal and installation of the valve of adjustment of pressure in back brake mechanisms
   Removal, installation and adjustment of the switch of lanterns
   The general description of system of antiblocking of brakes (ABS)
   Removal and installation of components of system ABS
   Removal and installation of the vacuum pump (diesel engines)
   Check of serviceability and partition of the vacuum pump (diesel engines)
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes



Removal, installation and adjustment of the switch of lanterns

 REMOVAL

1. The switch of lanterns of a stoplight is on an arm of pedals under the instrument panel.
2. To remove the switch, push a hand under the panel, disconnect a socket of electroconducting and turn out the switch from an arm.


 INSTALLATION AND ADJUSTMENT

1. Screw the switch into position in a fixing arm.
2. Connect an ohmmeter or a lamp on 12В to the independent power supply to switch plugs. Screw the switch so that the chain remained opened. Softly press a pedal and be convinced that the chain has become isolated after the pedal has passed approximately 5 mm. If it is necessary, repeat adjustment.
3. In the absence of an ohmmeter and a testing chain, execute adjustment in a similar way, having connected a socket and having asked the assistant to observe of stoplight lanterns.
4. Upon termination of adjustment, connect conducting and check up action of lanterns of a stoplight.