Renault Megane, Scenic

Since 1996 of release

Repair and car operation



Reno Megan, Stsenik
+ Cars of mark Renault Megane
+ Maintenance service
+ Engine repair
+ System of cooling, heating
+ Power supply systems, release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
- Brake system
   Prorolling of hydrosystem of brakes
   Replacement of brake tubes and hoses
   Replacement колодок forward brake mechanisms
   Replacement колодок back brake mechanisms
   Survey, removal and installation of a disk of the forward brake mechanism
   Removal, survey and installation of drums of back brake mechanisms
   Removal, partition and installation of supports of forward brake mechanisms
   Removal and installation of the cylinder of the back brake mechanism
   Removal, partition and installation of the main cylinder
   Removal and installation of a pedal of a brake
   Check, removal and installation of the block of the vacuum amplifier
   Removal, check and installation of the unilateral valve of the block of the vacuum amplifier
   Adjustment of a manual brake
   Removal and installation of the lever of a manual brake
   Removal and installation of ropes of a manual brake
   Check, removal and installation of the valve of adjustment of pressure in back brake mechanisms
   Removal, installation and adjustment of the switch of lanterns
   The general description of system of antiblocking of brakes (ABS)
   Removal and installation of components of system ABS
   Removal and installation of the vacuum pump (diesel engines)
   Check of serviceability and partition of the vacuum pump (diesel engines)
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes



Removal and installation of ropes of a manual brake

 REMOVAL

1. Back brake knots incorporate to the lever of a manual brake two ropes. Each rope can be removed separately as follows.
2. Block forward wheels, then поддомкратьте a back part of the car and establish it on axial props.
3. To get access to the basis of the lever of a manual brake, turn away fixing nuts/bolts and remove thermoisolation of final system.
4. Remove Pads a back brake as it is described in Section Replacement колодок back brake mechanisms.

5. Disconnect a tip of a rope and let out a rope from a basic board of a drum-type brake (address to an accompanying illustration).

6. Moving along a rope and marking its arrangement, let out it from all скоб and couplers (address to an accompanying illustration). Separate the forward end of a rope from an equalizer plate, then separate a tip of a casing of a rope from a body of the car and remove a rope.


 INSTALLATION

1. Make installation upside-down, using the labels made at removal. Before thermoisolation installation, adjust length of a rope as it is described in Section Adjustment of a manual brake.