Renault Megane, Scenic

Since 1996 of release

Repair and car operation



Reno Megan, Stsenik
+ Cars of mark Renault Megane
+ Maintenance service
+ Engine repair
+ System of cooling, heating
+ Power supply systems, release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
- Brake system
   Prorolling of hydrosystem of brakes
   Replacement of brake tubes and hoses
   Replacement колодок forward brake mechanisms
   Replacement колодок back brake mechanisms
   Survey, removal and installation of a disk of the forward brake mechanism
   Removal, survey and installation of drums of back brake mechanisms
   Removal, partition and installation of supports of forward brake mechanisms
   Removal and installation of the cylinder of the back brake mechanism
   Removal, partition and installation of the main cylinder
   Removal and installation of a pedal of a brake
   Check, removal and installation of the block of the vacuum amplifier
   Removal, check and installation of the unilateral valve of the block of the vacuum amplifier
   Adjustment of a manual brake
   Removal and installation of the lever of a manual brake
   Removal and installation of ropes of a manual brake
   Check, removal and installation of the valve of adjustment of pressure in back brake mechanisms
   Removal, installation and adjustment of the switch of lanterns
   The general description of system of antiblocking of brakes (ABS)
   Removal and installation of components of system ABS
   Removal and installation of the vacuum pump (diesel engines)
   Check of serviceability and partition of the vacuum pump (diesel engines)
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes



Removal and installation of the lever of a manual brake

 REMOVAL

1. To get access to the lever of a manual brake, remove the central console completely (models Scenic) or only its back part (all other models) as it is described in the Head the Body. Disconnect a socket of electroconducting from the switch of a control lamp of a manual brake and completely let out the lever.
2. Block forward wheels, then поддомкратьте a back part of the car and establish it on axial props.
3. Turn away fixing nuts/bolts and remove from under the lever of a manual brake thermoisolation of final system.

On some models probably it is necessary to separate the forward end of an intermediate pipe of final system that it was possible to remove thermoisolation (address to Section Removal and installation of final system or to Section the General description and replacement of components of final system).

4. Loosen the a counternut (where is available), then turn away an adjusting nut to receive the maximum free wheeling of ropes of a manual brake (address to an accompanying illustration).

5. Unhook ropes from an equalizer plate, then disconnect draught of the lever from the directing.

6. Loosen the also remove fixing nuts of the lever, then deduce assemblage from under the car (address to an accompanying illustration).


 INSTALLATION

1. Make installation in return sequence. Before thermoisolation installation adjust length of a rope of a manual brake as it is described in Section Adjustment of a manual brake.